Megatorque Motor Selection Name* Name Company name:* Location (City, State)* Phone*Email* Who would you like contact you?* Application Engineer Territory Sales Manager Industrial Distributor High Tech Distributor Company Type* End User Manufacturer Distributor (High Tech/Industrial) Application NeedsProduct Need by Date MM slash DD slash YYYY Application and equipment used(specify with as much detail as possible) ex: robotics, automotive assembly, semiconductor packaging, medical, machine toolSchematic drawingPlease provide information such outside dimensions, dimensions from the center, and material. .pdf, .doc, .xls, .stp file type uploads are acceptable.Accepted file types: pdf, doc, xls, stp, Max. file size: 64 MB.Motor installation position Upright position Horizontal position Upside-down position Load Conditions(1) Geometry, dimensions, thickness, material (or mass) of table (2) Dimensions, mass, quantity of loads/jigs (3) PCD (distance between the jigs/loads) (example of description) Schematic drawingMax. file size: 64 MB.Please provide information on outside dimensions, dimensions from the center, material, etc...)What is the external force? When and where is the external force being applied? None Always At settling During rotation Some impact Rotational direction Sliding friction Motor size requested Positioning command system Internal program system Pulse train input operation RS-232C operation CC-Link Index angle: Settle at in degreesNumber of points: Repeatability ± ± ____ seconds ( ± ____ mm at ____ mm from the motor center)Cycle Pattern(desired positioning time) Index Time (seconds)Setting Time (seconds)Operating Time (hours/days)Input power voltage 100 to 115 [VAC] 200 to 230 [VAC] Environmental conditions General enviornment (equivalent to IP30) Oil, water and chemical Chips and dust Clean 0°C to 40°C Below 0°C Above 40°C Other Cable Specification Stationary cable Flexible cable Select "Flexible" when cable is repeatedly bent anywhere along the wiring route.Length (m)Other requested itemsCommentsThis field is for validation purposes and should be left unchanged.